HMT Hardox Broach Cutter (to order only)
Available options shown below:
Ultra coated Multisink for increased wear resistance whilst countersinking the toughest materials like Hardox, Inconel and Armor plate. The MultiSink™ is a worldwide unique new Combination Countersink Tool designed & developed by HMT for use with Magnetic Drills. The multisink combines with the VersaDrive® product range to allow you to Broach & Countersink, Drill & Countersink, Tap & Countersink or even Drill, Tap & Countersink in one operation.
- Code - Hardox Broach Cutter
| 100mm Length 19.05mm (3/4") Weldon Shank 90 Degree point angle Countersink starting diameter = 14mm The extreme hardness and resistance of wear plate makes machining it extremely challenging. Good results are dependent on the right setup - including high torque/slow speed, geared Magnet Drills, such as the VersaDrive® V125T, and correct lubrication For predrilled holes the MultiSink should always be used with a pilot to avoid damage When used for multiple operations eg Drilling then Countersinking, the correct RPM should be used for each separate operation Constant coolant application is advisable to carry away any heat generated by cutting, as heat build up can cause work hardening Do not allow the countersink to vibrate over swarf while cutting as this will cause chatter, ultimately causing the cutting edge to chip & blunt |
ADD A REVIEW
Top Brands at Great Prices - Delivered Nationwide or Collect from our General Store in Cornwall
